316
edits
Remco.derooy (talk | contribs) m (Remco.derooy moved page Investigating network problems on remote sites to Analyze connections between remote sites: the page does not describe any information about "Investigating network problems on remote sites".) |
Remco.derooy (talk | contribs) |
||
Line 19: | Line 19: | ||
# You need two Allegro Network Multimeters (any model). | # You need two Allegro Network Multimeters (any model). | ||
# One Multimeter (the master device) will receive traffic information from the remote Multimeter via a | # One Multimeter (the master device) will receive traffic information from the remote Multimeter via a standard SSL connection; the master device must be able to connect to the remote device. If a firewall is in place between both devices, an additional rule might be necessary to connect the remote device on port 443. | ||
== Device installation == | == Device installation == | ||
# Install the master device in your network where it can see the traffic sent and | # Install the master device in your network where it can see the traffic sent and received to the remote site. The Multimeter can be installed on a Mirror Port of a Switch which sees all the traffic, or inline between the local network and uplink to the remote site. | ||
# Install the device on the remote site at a network position where it sees all traffic from and to the local network. Again, this can be a Mirror Port | # Install the device on the remote site at a network position where it sees all traffic from and to the local network. Again, this can be a Mirror Port of a Switch on the remote site, or inline between the remote network and the link to the local network. | ||
== Configuration == | == Configuration == | ||
Line 32: | Line 32: | ||
|} | |} | ||
# Remote device: | # Remote device: First, the remote device must be added to your multi-device setup, which can be configured under [[Multi-device settings|<u>Multi device settings</u>]]. | ||
# Master device: | # Master device: | ||
## Access the web page of the Multimeter and go to "Generic -> Path measurement". | ## Access the web page of the Multimeter and go to "Generic -> Path measurement". |
edits