Path measurement: Difference between revisions

* Maximum packet delay: This field describes the maximum amount of seconds to wait for packet information from the remote device.

:The settings must be saved but to actually take effect, a restart of the packet processing is necessary. If this step is required will tell so at the bottom of the page under '''Required actions'''.

:'''Parameters currently in use:''' This section shows the current state of the measurement engine. The engine might be inactive even if the feature is enabled. Usually a restart is required to actually make it active. If active, the current packet delay is shown. It might be different from the selected value in the configuration above, but if so a note appears that a restart is required.

:'''Required actions:''' An info box appears if the a restart of the packet processing is required. The shown link leads to the page '''Settings → Administration''' where the restart can be triggered. The device itself does not need to be rebooted, only the packet processing must be restarted which usually takes only a few seconds.

:'''Custom remote device SSL certificate:''' If a custom SSL certificate is installed on the remote device, you have to upload the public certificate to the master device as well.  Otherwise you will get a SSL error during connect to the remote device. Select the PEM certificate and click on '''Install certificate''' to upload it to the device. You can also remove an already installed certificate by clicking on the '''Remove certificate''' button.