1,775
edits
Path measurement: Difference between revisions
no edit summary
No edit summary |
No edit summary |
||
| Line 48: | Line 48: | ||
* Maximum packet delay: This field describes the maximum amount of seconds to wait for packet information from the remote device. | * Maximum packet delay: This field describes the maximum amount of seconds to wait for packet information from the remote device. | ||
:The settings must be saved but to actually take effect, a restart of the packet processing is necessary. If this step is required will tell so at the bottom of the page under '''Required actions'''. | :The settings must be saved but to actually take effect, a restart of the packet processing is necessary. If this step is required will tell so at the bottom of the page under '''Required actions'''. | ||
Parameters currently in use: This section shows the current state of the measurement engine. The engine might be inactive even if the feature is enabled. Usually a restart is required to actually make it active. If active, the current packet delay is shown. It might be different from the selected value in the configuration above, but if so a note appears that a restart is required. | :'''Parameters currently in use:''' This section shows the current state of the measurement engine. The engine might be inactive even if the feature is enabled. Usually a restart is required to actually make it active. If active, the current packet delay is shown. It might be different from the selected value in the configuration above, but if so a note appears that a restart is required. | ||
:'''Required actions:''' An info box appears if the a restart of the packet processing is required. The shown link leads to the page '''Settings → Administration''' where the restart can be triggered. The device itself does not need to be rebooted, only the packet processing must be restarted which usually takes only a few seconds. | :'''Required actions:''' An info box appears if the a restart of the packet processing is required. The shown link leads to the page '''Settings → Administration''' where the restart can be triggered. The device itself does not need to be rebooted, only the packet processing must be restarted which usually takes only a few seconds. | ||