Generic Allegro Network Multimeter installation: Difference between revisions
Jump to navigation
Jump to search
Access restrictions were established for this page. If you see this message, you have no access to this page.
(Created page with "All Allegro Network Multimeter share the same basic installation steps. An quick installation guide is provided with each device as a printed document or at our [https://alle...") |
No edit summary |
||
| Line 2: | Line 2: | ||
An quick installation guide is provided with each device as a printed document or at our [https://allegro-packets.com/en/support web site]. | An quick installation guide is provided with each device as a printed document or at our [https://allegro-packets.com/en/support web site]. | ||
The basic steps, described in detail in the installation guide, are: | |||
# Connect the external power supply or cable to the internal power supply. | |||
# Connect the LAN connection for the management access | |||
# Or connect the WiFi device for wireless access | |||
# Setup bridge or sink mode depending on whether you want to deploy the device in-line or on a passive tap or mirror port. | |||
# Connect the measurement ports | |||
# Start the device | |||
# Access the web interface | |||
Revision as of 08:09, 23 April 2020
All Allegro Network Multimeter share the same basic installation steps.
An quick installation guide is provided with each device as a printed document or at our web site.
The basic steps, described in detail in the installation guide, are:
- Connect the external power supply or cable to the internal power supply.
- Connect the LAN connection for the management access
- Or connect the WiFi device for wireless access
- Setup bridge or sink mode depending on whether you want to deploy the device in-line or on a passive tap or mirror port.
- Connect the measurement ports
- Start the device
- Access the web interface