Generic Allegro Network Multimeter installation: Difference between revisions
Jump to navigation
Jump to search
Access restrictions were established for this page. If you see this message, you have no access to this page.
m (→Device specific installation guides: always list english version first) |
(→Device specific installation guides: Add Allegro 1010/3010 installation guides) |
||
| Line 28: | Line 28: | ||
| Allegro 800<br>Allegro 1000/1200<br>Allegro 3000/3200 | | Allegro 800<br>Allegro 1000/1200<br>Allegro 3000/3200 | ||
|[[Media:Installation Guide Allegro 800-1000-3000 (English).pdf|Installation Guide 800/1000/1200/3000/3200 (English)]]<br>[[Media:Installation Guide Allegro-200-1000-3000-dt.pdf|Installation Guide 1000/1200/3000/3200 (Deutsch)]] | |[[Media:Installation Guide Allegro 800-1000-3000 (English).pdf|Installation Guide 800/1000/1200/3000/3200 (English)]]<br>[[Media:Installation Guide Allegro-200-1000-3000-dt.pdf|Installation Guide 1000/1200/3000/3200 (Deutsch)]] | ||
|- | |||
| Allegro 1010<br>Allegro 3010 | |||
|[[Media:Installation_Guide_1010-3010_en.pdf|Installation Guide Allegro 1010/3010 (English)]]<br>[[Media:Installation_Guide_1010-3010_de.pdf|Installation Guide Allegro 1010/3010 (Deutsch)]] | |||
|- | |- | ||
|Allegro 1210/3210/5210 | |Allegro 1210/3210/5210 | ||
Revision as of 12:15, 9 October 2024
Generic install information
All Allegro Network Multimeters share the same basic installation steps.
A quick installation guide is provided with each device as a printed document or on our web site.
The basic steps, described in detail in the installation guide, are:
- Connect the external power supply or cable to the internal power supply.
- Connect the LAN connection for management access,
- Or, connect the Wi-Fi device for wireless access.
- Setup Bridge or Sink mode depending on whether you want to deploy the device in-line or on a passive Tap or Mirror Port.
- Connect the measurement ports.
- Start the device.
- Access the web interface.
Note that an initial configuration of the Management interface settings on console is possible.