Generic Allegro Network Multimeter installation: Difference between revisions
Jump to navigation
Jump to search
Access restrictions were established for this page. If you see this message, you have no access to this page.
mNo edit summary |
m (→Device specific installation guides: always list english version first) |
||
| Line 27: | Line 27: | ||
|- | |- | ||
| Allegro 800<br>Allegro 1000/1200<br>Allegro 3000/3200 | | Allegro 800<br>Allegro 1000/1200<br>Allegro 3000/3200 | ||
|[[Media:Installation Guide Allegro | |[[Media:Installation Guide Allegro 800-1000-3000 (English).pdf|Installation Guide 800/1000/1200/3000/3200 (English)]]<br>[[Media:Installation Guide Allegro-200-1000-3000-dt.pdf|Installation Guide 1000/1200/3000/3200 (Deutsch)]] | ||
|- | |- | ||
|Allegro 1210/3210/5210 | |Allegro 1210/3210/5210 | ||
Revision as of 12:09, 9 October 2024
Generic install information
All Allegro Network Multimeters share the same basic installation steps.
A quick installation guide is provided with each device as a printed document or on our web site.
The basic steps, described in detail in the installation guide, are:
- Connect the external power supply or cable to the internal power supply.
- Connect the LAN connection for management access,
- Or, connect the Wi-Fi device for wireless access.
- Setup Bridge or Sink mode depending on whether you want to deploy the device in-line or on a passive Tap or Mirror Port.
- Connect the measurement ports.
- Start the device.
- Access the web interface.
Note that an initial configuration of the Management interface settings on console is possible.